Home > Imaging > Imaging Software

Imaging Software

The Proxima AQ-4 software is compatible with all our Proxima, Ultima and OptiGo imaging systems.

ImaGo systems will only work with the ImaGo software which is also available below.

The ProXima Downloads

The latest version of the Proxima AQ-4 software: 1.29.
The latest version of the ProXima Firmware is V-0.31R.

For the older ProXima 10phi(+) and (C)16phi(+) the latest version is 1.10b.

You need to register your imaging-unit to download our newest version of the Proxima AQ-4 software (incl. manual).
Please register here

List of improvements and changes of the aquisition software (AQ) since its release: ChangeLog.txt
List of improvements and changes of the ProXima 2000 series firmware since its release:Firmware-changeLog.txt

Ultima downloads

For historical and archival purposes only.
You are adviced to use ProXima AQ-4 1.10b, downloadable from the link above on systems running Windows Vista, 7, 8, 8.1, 10 or up.

Ultima 10si: Setup-ULTima-AQ-10Si.exe
Ultima 16si-Pro with IC in their serial numbers: Setup-ULTima_AQ_285.exe
Ultima 16, 16si-Plus en 16si-Pro without IC in their serial number: Setup-ULTima-AQ-16Si-Pro.exe

Optigo downloads

For historical and archival purposes only.
You are adviced to use ProXima AQ-4 1.10b, downloadable from the link above on systems running Windows Vista, 7, 8, 8.1, 10 or up.

OptiGo general: OptiGo manual
OptiGo 500: OptiCom500Setup.exe
pre-June 2006 OptiGo 600/650: Setup-600.zip
Optigo 700/750 with IC in their serial numbers: OptiCom285Setup.exe
Optigo 600, 650, 700, 750 without IC in their serial numbers: OptiCom600M700Setup.exe

ImaGo downloads

Download here the latest version of the ImaGo user manual.

Installation and startup of ImaGo firmware, version 3.01:

  • First download the newest software for your ImaGo here. This ImaGo software is always available from this website.
  • Before you unzip the contents and start the setup program, you need to be sure to uninstall the previous version of the ImaCom software. This can be done by using the control panel, add/remove software and selecting the ImaCom software.
  • After installation of the new version of the ImaCom software you need to configure the communication ports as described in the manual (is the same as the older versions).
  • Once this is done, the firmware upload of the ImaGo can be started. The initial password is: BLS.
    Be sure to have the ImaGo switched off before you start this operation. For the next steps, follow the instructions on the screen.